BGKRW - S-235 MULTIPURPOSE ADHESIVE

  • MSDS: BGKRW
  • Manufacturer: ARMSTRONG
  • Product Name: S-235 MULTIPURPOSE ADHESIVE
  • National Stock Number: 8040-01-078-0737
Product Identification

Product ID:S-235 MULTIPURPOSE ADHESIVE
MSDS Date:07/01/1991
FSC:8040
NIIN:01-078-0737
MSDS Number: BGKRW

Responsible Party
ARMSTRONG
313 W LIBERTY ST
LANCASTER, PA 17604
US

Emergency Phone: 717-396-2328; 717-396-2935

Info Phone: 717-396-2328; 717-396-2935

Cage: MO840

Contractor
ARMSTRONG WORLD INDUSTRIES, INC.
3209 LANCASTER, PA 17604 US

Telephone: 717-396-2328; 717-396-2935

Cage: 03938

Ingredients

TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 3-4%

OSHA PEL 200 PPM/150 STEL

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:NOTE:TOLUENE (108-88-3) APPEARS ON
NAVY LIST OF OCCUP CHEMICAL REPRO HAZARDS. CONSULT WITH PROFS
CONCERNING LATEST HAZARD LIST INFO & SAFE HNDLG & EXPOS RECS .
TARGET ORGANS:UPPER RESPIRATORY TR ACT, SKIN, EYES.
SKIN/EYES:EXCESSIVE SKIN CONTACT MAY CAUSE DRYING & CRACKING OF
SKIN, DEFATTING OF (EFTS OF OVEREXPOS)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:TISSUE & RESULT IN DERMATITIS. CONTACT
W/EYES WILL CAUSE IRRITATION. INHAL:TOLUENE IS KNOWN TO CAUSE
IRRITATION OF RESPIRATORY TRACT, COUGHING, HEADACHE, DIZZINESS,
DROWSINESS, NAUSEA, UNCOOR INATED MOVEMENTS.
Medical Cond Aggravated by Exposure:ANY CONDITION GENERALLY AGGRAVATED
BY SOLVENTS, INCLUDING PREEXISTING UPPER RESPIRATORY & LUNG DISEASE
SUCH AS, BUT NOT LIMITED TO BRONCHITIS, EMPHYSEMA & ASTHMA.
EXISTING SKIN CONDITIONS.

First Aid

First Aid:SKIN:FLUSH W/PLENTY OF WATER. ADDITIONALLY, WASH W/SOAP &
WATER. REFER TO MD IF IRRITATION OR SYMPTOMS PERSIST. EYE:FLUSH
W/PLENTY OF WATER FOR AT LEAST 15 MINUTES. REFER TO MD IF
IRRITATION OR SYMPTO MS PERSIST. INHAL:REMOVE TO FRESH AIR IF
EXPOSED TO EXCESS CONCENTRATIONS OF VAPOR. SEEK MEDICAL ATTENTION
IF SYMPTOMS PERSIST. INGEST:DO NOT INDUCE VOMITING. CALL POIS CTL
CTR OR MD FOR GUIDANCE.

Fire Fighting

Flash Point Method:SCC
Flash Point:>200F,>93C
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, HALON, WATER SPRAY.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS IN A FIRE MAY RUPTURE
DUE TO PRESSURE BUILD-UP; USE WATER TO COOL CONTAINERS TO PREVENT
THIS.

Accidental Release

Spill Release Procedures:VENTILATE AREA OF SPILL OR RELEASE. EXTINGUISH
OPEN FLAMES & HEAT-PRODUCING EQUIPMENT. SCRAPE UP PRODUCT & PLACE
INTO CONTAINER. RESIDUAL OF PRODUCT CAN BE CLEANED UP W/WARM SOAPY
WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE IN AREA SUITABLE FOR COMBUSTIBLE
MIXTURES. RECOMMENDED STORAGE TEMPERATURE IS <90F.
Other Precautions:VAPORS ARE HEAVIER THAN AIR. USE PRECAUTIONS THAT ARE
COMMON W/SAFE HANDLING OF COMBUSTIBLE LIQUIDS.

Exposure Controls

Respiratory Protection:WITH ADEQUATE VENTILATION, RESPIRATORY EQUIPMENT
SHOULD NOT BE NEEDED. IF ADEQUATE VENTILATION IS NOT AFFORDED, WEAR
NIOSH/MSHA APPROVED RESPIRATORY EQUIPMENT FOR ORGANIC VAPORS.
Ventilation:USE NATURAL CROSS-VENT, LOC(MECH) PICK-UP, &/OR GEN
AREA(MECH) VENT TO PVNT ACCUM OF SOLV VAPS, KEEPING IN MIND
(SUPDAT)
Protective Gloves:COTTON/LOOPPILE
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
VENT:THAT VENTILATION PATTERN MUST REMOVE HEAVIER THAN AIR SOLVENT
VAPORS FROM LOWER LEVELS OF WORK SPACES, VENTILATION SHOULD BE
SUFFICIENT TO KEEP SOLVENT VAPOR CONCENTRATION BELOW TLV.

Chemical Properties

Spec Gravity:1.18 (H*2O=1)
Solubility in Water:APPRECIABLE
Appearance and Odor:OFF-WHITE, HEAVY-BODIED PASTE W/SLIGHT AROMATIC
ODOR.
Percent Volatiles by Volume:33(WT)

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE &
OTHER TOXIC VAPORS & GASES THAT ARE COMMON TO THERMAL DEGRADATION
OF ORGANIC CMPDS.

Disposal

Waste Disposal Methods:INCINERATION OR OTHER METHOD APPROVED I/A/W
FEDERAL, STATE & LOCAL REGULATIONS. THIS PRODUCT CONTAINS CHEMICAL
SUBJECT TO REPORTING REQUIREMENTS OF SECTION 313 OF TITLE III OF
SARA ACT & 40 CFR 372.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.